PDMS to Tribon Drafting comparison

|

1. Scope

The scope of this document is to provide a simplified comparison based on PDMS Draft and Tribon Drafting.

2. Purpose

The purpose of this document is to give an overview of two 3D- drafting systems and underline the differences between them.

3.

2011/10/16 21:15

PDMS to Tribon modeling comparison

|

1. Scope

The scope of this document is a simplified model comparison based on PDMS Structural Design and TRIBON Hull Design.

2. Purpose

The purpose of this document is to give an overview of two 3D- modeling systems and underline the differences between them.

3.

2011/10/16 21:15

PDMS Reports

|

 - Select Utilities > Reports > Create...

- Key in Selection fields (see pictures 1 and 2)

- Press New- button to add column and in key the Expression needed (see picture3).

Note that new column is created above selected column.

- Picture 4 shows layout settings for column 1.

2011/10/25 20:55

PDMS Lists

|

 - Select elements to be treated in Members & Draw List

- Select Utilities > Lists...

- Add elements to be treated Add > List… > Key in list name

2011/10/25 20:55

PDMS guide | Beginners: Interface, Settings, Modeling and Drafting

|

1 Interface

1.1 Login

To be able to login to PDMS, user needs to select 1) Project, 2) Facility, 3) Sub Facility, 4) User Role, 5) Module (Design, Draft, etc.) and 6) Databanks (Design, Draft, etc.), see picture 1 below.

Note that once selections have been made, they stay active until changed again.

2011/10/25 20:45

PDMS QUERY Commands

|

Command
Explanation
Q CECurrent element
Q MEMCE Members

Article written by Marko Ervonmaap

2011/10/25 20:45

PDMS Terms

| |

Term
ExplanationNotes
CATREFCatalogue Reference
CREFConnection Reference
Article written by Marko ErvonmaaPlease do not hesitate to send your feedback or ask any question.

2011/10/25 20:35

PDMS DRAFT Check List

|

The purpose of this checklist is to provide general guidelines to check a drawing in Draft. Some of the checks are on-going, some of should be performed once a week or when drawing is finished and is ready to be issued.

1. Check references of drawing, sheet and view levels

2011/10/25 20:35